ANUBIS Typhoon Wireless Access Point Setup Guide download pdf (Page 9)

Hardware Setup

After you've selected your receiver device at General Config, you can configure the hardware and learn the

buttons of your remote control or define keyboard Hotkeys at Hardware Setup. The figure below shows the setup

screen for TV capture boards, note that the upper part may look different for your receiver device.

Configure your hardware and click Initialize. For help on driver settings, click the Info button at General

Config|Device Selection or look under the Devices book in this help file.

You can adjust several remote control settings by selecting a remote control's label:

Typematic

AntiRepeat

Once the hardware is running, you can start learning buttons or setting up Hotkeys

. If you are unsure whether you

have your device properly configured, just try to learn to see whether uICE receives input.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 100 101

No comments

ANUBIS Typhoon Wireless Access Point Setup Guide Page 9