ANUBIS POS50 User Manual

1 QQuuiicckk GGuuiiddee PPOOSS5500 SSeerriieess AApprriill.. 22000066 ((VV11..00))

10

11

3.3 MSR / I-Button PS2 interface Installation a. The MSR Kit included Bracket and Module. b. Turn the system to rear side.

d. Screw up the MSR module and connect the cable into connector. 13 33..44 CCaasshh DDrraawweerr

Chapter 4 Jumper Definition 4.1 Main Board Layout 14

15 4.2 LCD Power setting • JP2: This jumper is for the setting of LCD panel voltage. JP2 Description 2-4 +3.3V 4-6 +5V • JP2: This jumper is f

16 33 SA1 34 CABLE_80P 35 SA0 36 SA2 37 HDC CS0# 38 HDC CS1# 39 HDD ACTIVE# 40 GROUND 41 VCC5 42 VCC5 43 GND 44 b. CN8: Compact Flash Storag

17 4.7 Serial Ports The system provides three high speed NS16C550 compatible UARTS with Read/Receive 16 byte FIFO. Four com ports are in IO connector

18 • CN21: Power Connector Input PIN Description PIN Description 1 GND 3 Power IN(+12V)2 GND 4 Power IN(+12V) • CN28: Power Connector Output P

19 3 GROUND 4 N/C 5 +12V 6 GROUND 4.11 USB Port Connector • USB1: CN22 • USB2: CN23 • USB3: CN31 • USB4: CN15 PIN Description 1 +5V 2 DA

2 CCOONNTTEENNTTSS Chapter 1 Unpacking ------------------------------------------------------

20 PIN Description 1 Reset button + 2 Reset button - 4.15 Cash Drawer Connector • CN20 PIN DESCRIPTION PIN DESCRIPTION 1 GROUND 2 DOUT_0 3 DIN

3 Chapter 1 Unpacking Unpacking the POS Terminal, please check the following items are presented and in good conditions: a. Main Unit

Chapter 2 Specification 2.1 Specification The POS system configuration including 8.4”, 12.1” and 15” as followings,

2.2 I/O ports Following ports show all of ports of system. a. DC IN: connector for power adapter input 12VDC. b. Cash Drawer: prov

Chapter 3 Installation 3.1 OS Installation 3.1.1 Embedded WEPOS / WinCE CD ROM Driver with USB interface If you bought the system includ

d. Select “First Boot Device” to “USB-CDROM”. e. Press “F10” to save setup change and quit. f. Install the Win XP,

8

9