ANUBIS KV-MRD900 User Manual download pdf (Page 10)

ENGLISH

You can listen to the playback sounds with

cordless headphones—KS-HP2.

Installing the batteries

CAUTIONS:

• The supplied batteries are not rechargeable.

DO NOT recharge them; otherwise, battery

leakage or explosion may result.

• Insert the batteries with the correct polarity

“+” and “–” to prevent the battery leakage

or explosion.

Before using the cordless headphones:

The headphones give best results when used

within about 2 m from the transmitter.

These headphones need to receive infrared (IR)

signals sent from IR transmitters on the monitor.

Therefore, if you use the headphones where the

signals cannot be received in a straight line of

sight, noises may be generated.

Main elements and features

1 IR sensors

• DO NOT cover the IR sensors, as

reception will become poor.

2 ON/OFF button

• The power automatically shuts off in the

following cases:

– The headphones are used for about 4

hours.

– No signal is received for about 4

minutes.

• You can turn on the power again by

pressing the button.

3 POWER lamp

4 Volume control

Playback sounds are transmitted through IR

transmitters to the cordless headphones.

When using the headphones, set the monitor

menu item “IR” to “ON.” (See page 14.)

WARNING:

DO NOT use the headphones while driving.

Shutting out all outside sounds while driving

is dangerous and may result in a traffic

accident.

Headphones — KS-HP2

Left side Right side

IR transmitters

POWER

VOL

Batteries (R03/AAA)

— supplied only for

initial setup purpose

EN07-10_KV-MRD900[E]f.indd 10EN07-10_KV-MRD900[E]f.indd 10 05.3.19 0:22:24 PM05.3.19 0:22:24 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

ANUBIS KV-MRD900 User Manual Page 10

Comments to this Manuals